tag:blogger.com,1999:blog-20340207.post8423585422820720451..comments2024-03-29T14:03:44.804+00:00Comments on Phil's Workbench: Gluing Plastikard to MDFUnknownnoreply@blogger.comBlogger3125tag:blogger.com,1999:blog-20340207.post-46640537130103797682020-02-11T18:12:35.470+00:002020-02-11T18:12:35.470+00:00Steve - I had no problem over 25 years doing this ...Steve - I had no problem over 25 years doing this with plastic to card. The MDF is very strong though, so I wouldn't expect any issue. <br /><br />Christopher - Because I followed the photo on the kit. Perhaps this explains why I shouldn't follow instructions!Phil Parkerhttps://www.blogger.com/profile/15673614093646938053noreply@blogger.comtag:blogger.com,1999:blog-20340207.post-2354816174695060502020-02-11T16:20:57.772+00:002020-02-11T16:20:57.772+00:00Have you had any problems with buildings warping w...Have you had any problems with buildings warping when gluing embossed plastikard to MDF ? I've certainlly experienced it with all-plastikard construction or brick paper to plastikard. One approach is to try to "balance" by sticking an equivalent weight on the back face.... Or maybe the MDF is thick and rigid enough for it not to matter ?<br /><br />Great blog, a modelling ray of sunshine !!Steve Cheethamhttps://www.blogger.com/profile/10221666072762668912noreply@blogger.comtag:blogger.com,1999:blog-20340207.post-88471747352307714612020-02-11T10:29:19.248+00:002020-02-11T10:29:19.248+00:00
Why are the cross plates positioned where they ar...<br />Why are the cross plates positioned where they are? The tie rods that would be connected to them will be above floor level and of reduced effect so close to the side walls.<br /><br />Christopher PayneChristopher Paynehttps://www.blogger.com/profile/01200929388032991464noreply@blogger.com