Saturday, July 29, 2006

A hole lot of work


Hole
Originally uploaded by Phil_Parker.
You should always build a working chassis before making the body. If you don’t you can find yourself spending a Friday night hacking your way through bits of a complete body in order to get the motor in.

I started with a slitting disk as far up the sides of the bulkhead as I could. Then I tried burs and grinders to do the rest. Nothing really worked so I used some tin snips to cut the metal up a bit. The leftovers were then twisted and waggled with small pliers to break them off. Not too bad in the case of the bulkhead at the end of the bonnet – the soldered joint gave way eventually allowing the mostly complete piece to be removed. The cab front gave more of a struggle it came as well.

A little soldering where the top of the bonnet had become loose, some filing on the sides to tidy the hole up – yes that is the tidy hole on the photo - and the motor went in. Good job the cab is so enclosed that you can’t see the back end of Mashima where the controls should be !

No comments:

Post a Comment