Finger pulled out, progress on my Chairman's Challenge boat starts again.
The first job is to build a new mock up for the superstructure as the first version wasn't a complete success.
I liked the front windows so these have stayed but the new design has all the panels the same width, including the door which had been far too narrow before. Since this is supposed to be a sliding panel, the section behind had better be wide enough to accommodate it too.
The proportions are a lot better. I'll need to make the back cabins about 15mm longer to balance the look but just by placing the cardboard creations on the deck, i can see this is much batter balanced and closer to the prototype I'm sort of basing it on.
No comments:
Post a Comment