Thursday, December 13, 2018

Making holes in the side


Making some holes in the upper levels of Mohan's hull adds character and, depending on their purpose, lets the water run off the deck.

At the front, the holes are to let ropes through to the bollard at the front of the boat. Making these is simple, just drill a hole and then open it out with the largest tapered reamer in my possession. This limits the size of the opening, but as this is a freelance model, if it looks right, it is right.

A thin sliver of plastic is fitted around the inside of the hole and generously washed with solvent. Once hard, I sand it back with an abrasive stick giving a nice, neat finish.


The freeing ports at the back are a little tricker. After drawing the desired lines on the bulwarks,  I drill out the corners, then open them with the reamer. Then the straight lines are cut with an Olfa cutter. A little bit of filing and fiddling, then some strip around the edge followed by some filler and the job is done.

The general wonkiness of the hull hasn't made this job easy, but I'm happy with the results. To be honest, the freeing ports aren't going to let much water out as they finish 3mm above the deck, but I decided against cutting through the quarter-round strip bracing the side/deck corner. 

1 comment:

GeoffinOz said...

Even though I am a railway modeller, I enjoy watching your boats get built. It gives me ideas to build one myself as I have a large Dam(Pond) on my property.