The Sand Scorcher body is supported on a single pin, with a clip, at the front, and with this clip at the back. To remove it, you reach in through the unglazed rear window, and pull the metal clip up. It seems to work, which shouldn't be a surprise, but is.
The clip is supported on a couple of tubes. I had them in the pot, but when I came to fit it, only one was still there. Hmmm. Anyway, I have some styrene tube about the right size, so made a couple out of that, which seems to work OK. I've also run out of the correct washers for the top of the roof, but found some nice wide ones to use instead. These should be fitted underneath I think, according to the instructions, but the washers there show threadlock around them, so we'll leave well alone.
Glazing is screwed in place, and by now I'd only got two of the three proper bolts, but plenty of some 2mm longer. No idea how this has happened, but some cutters quickly removed the extra couple of mm, and in the clear item went.
No comments:
Post a Comment